Programming Tone; Other Operating - Whirlpool MIcrowave Ovens Use And Care Manual

Programming tone
Each time you touch a pad you will hear a tone If you do not hear a tone, it is
because the Instruction is not correct, or it IS because the tones have been removed
EXAMPLE: If you forget to plug in the Temperature Probe and touch PROBE TEMP you will
not hear a tone. The instruction is not correct.
It you want to remove the tone:
l
Open the door.
l
Touch CANCEL twice, then START.
l
The tone will not sound for any touch
If you want to replace the tone:
l
Open the door
l
Touch CANCEL twice, then START.
l
The tone will sound for any correct touch
Other operating hints
These are a number of thongs you can do wrth your mlcrowave oven Some WIII be
reminders Others WIII be mentioned for the first trme
1 To double check settings whrle the oven IS running, touch the command pad for the
setting you want lo check The instructron programmed for that pad WIII show on
the Drsplay for 5 seconds Then the Drsplay returns to show what the oven IS doing
2 To stop the oven while it is running:
l
Open the door The oven WIII stop You can restart It by closrng the door and
touching START
. Touch CANCEL All rnstructrons will be erased You must touch In new Instructions
3 If you touch two Instructions Into the same cycle. the second rnstructrons will erase
the first
4 When using a Cook Power other than high the Drsplay will show the Cook Power for
2 seconds of every 10 during cookrng
5 When COOK CYCLE 1 follows QUICK DEFROST, a standing time equal to the defrosting
time will occur between the two COOK CYCLE 1 will automatically begin after this
standing time
22