Installation; Additional Handle; Fitting A Tool; Removing A Tool - Parkside PAH 1300 B2 Translation Of The Original Instructions

Installation

Additional handle

♦ You can position the additional handle
you wish.
♦ Undo the knurled nut
♦ Swing the additional handle
appliance axis or 180° forward or backward
into the desired position (see foldout page).
♦ Retighten the knurled nut

Fitting a tool

The supplied grease is solely for greasing
the tool holder
♦ Pull the locking sleeve
♦ Before fitting a tool into the tool holder
grease it lightly.
♦ Insert the tool with a rotating movement in the
tool holder until it clicks into itself.
♦ Release the locking sleeve
This locks the holder.
Check that the tool is properly locked by pulling
it. The system has radial play because of the
design.
│ GB │ IE
■ 16
as
.
around the
.
.
backwards.
,
.

Removing a tool

♦ Pull the locking sleeve
the tool out of the tool holder

Adjust chisel position

♦ You can adjust the flat chisel
working position.
♦ Place the flat chisel
♦ Push the chisel adjustment ring
turn with the chisel adjustment ring
chisel to the required position.
♦ Release the chisel adjustment ring
until it clicks.

Operation

Switching on and off
During operation, you can choose between
instantaneous and continuous operation.
Switching to instantaneous operation
♦ Press the ON/OFF switch
Switching off instantaneous operation
♦ Release the ON/OFF switch
Switching to continuous operation
♦ Press the ON/OFF switch
position with the locking switch
Switching off continuous operation
♦ Press the ON/OFF switch
again.
backwards and pull
.
in optimal
into the tool holder .
forward and
the flat
and turn it
.
.
and lock it in this
.
and release it
PAH 1300 B2