unios Linear Series Quick Start Manual

Strip Mounting
1 2
Recommended cleaning products:
Wax and grease remover, methylated
spirits, isopropyl alcohol or
surface cleaners.
Cutting Guide
Model: 6mm Strip
(EC60XXXX.FPXX)
+
-
20mm
Parts
2x Mounting Clips 2x Mounting Screws 2x End Caps
(per metre) (per metre) (per metre)
Edition 10.9.20 | Product design and technical data may be subject to change
unios.com
Page 4/4
IMPORTANT: Refer to ESD Protection Section
located on page 1 before mounting strip.
3
Eclipse G2
Avoid pressing LED
too hard and/or sliding
fingers across strip.
Aluminium Channel
Corrosion Protection
It is important to note that care must be taken
during installation or maintenance to ensure that
the surface of the luminaire is not damaged. Any
damage, which is exposed to moisture will result
in corrosion occurring.
Please also note that any chemical applications on
the luminaire or chemical contact via installation will
cause corrosion of the surface of the luminaire and will
void the warranty.
Ambient Conditions
Recommended to install in an
ambient temperature <35°C.
Disposal
Ensure correct disposal of this
product (waste electrical and
electronic equipment).
Eclipse G2 Glide Mini
Base 6mm Strip Glide Mini GS10
Codes
EC60XXXX -GS10XX.XX
Class III IP Rating Material
20 Aluminium
24V DC
CAUTION – This product must be installed by a qualified installer
Please read instruction manual carefully before installing luminaire
Surge Protection
For comprehensive protection of a luminaire against electrical surges, surge protection shall be installed
on the mains supply where required to protect luminaires and drivers from transient voltage damage.
For warranty information visit unios.com/warranty
Please read these installation instructions carefully before installing this product. This product must be installed and
maintained by a suitably qualified person/s in compliance with the latest applicable regulations and relevant legislation.
Unios does not warrant any claim based on defects or damage caused by misuse, improper installation, improper
operation and/or modifications carried out by the purchaser or third parties. This product shall not be used as a
'working light' during construction. This will result in the warranty of the product to be void. For warranty duration,
please refer to the data sheet.
ESD Protection
When Handling this product, care must be taken so that the LED strip is not
damaged. Damage due to inappropriate handling is not covered by warranty.
The following precautions must be taken:
• Ensure device is switched off and disconnected from power supply.
• During assembly/disassembly, care must be taken during handling of LED strip.
• Always ensure to discharge yourself of all charge by touching a grounded bare metal
surface or approved anti-static mat before working on device.
Twisted Sagging/Hanging
Glide Mini GS10
Edition 10.9.20 | Product design and technical data may be subject to change
Page 1/4
LINEAR SERIES
Install Person/s
1-2
Contains parts and
assemblies susceptible to
damage by electrostatic
discharge (ESD)
Installed without Cutting outside
aluminium channel designated area
+
-
1.1
11.2
unios.com
Power
10 Watts
CAUTION