3devo SHR3D IT Quick Start Manual page 2

Warranty
For information about the
3devo warranty policy visit:
www.3devo.com/warranty
Remove the packaging
Remove the top accessory box. Then remove the top foam
blocks. Lift out the SHR3D IT with two persons and place it on
a flat surface. Finally remove the plastic cover bag from the
SHR3D IT.
Set up the Shredder
1) Push hopper locking lever down and slide
hopper inside. Release lever to lock the
hopper in place.
5) Plug in the power cable and turn on the
power switch at the back of the machine.
9) Press the red button down to stop the
machine.
Support
For more information or
technical support visit:
www.3devo.com/support
2) Open interlock guard.
6) Check if both indicator lights are turned
on.
10) Open the interlock guard to slide out the
granulate collector.
Safety instructions
Wrong use of the machine and/or manipulating safety
switches may lead to severe injuries or failure of the
machine. The manufacturer is not liable for any problems
caused by the user's failure to observe the instructions stated
in the manual.
Check if the voltage in your power socket corresponds to that
of the purchased product.
Always wear personal protective equipment during use of
the machine. Wear ear protection, safety glasses and cut
resistant gloves when working with knives. Wear a gas mask
when working with plastics that release toxic gasses or dust.
Never change or remove guards when the machine is
powered.
Do not shred non-plastics.
Thoroughly read and adhere to ALL the safety instructions
as stated in the manual:
www.3devo.com/manuals
3) Slide the granulate collector in.
7) Press the green button down for one
second to start the machine.
4) Close interlock guard.
8) Throw in plastic parts and wait until the
part is processed into granulate.