Table of Contents
Advertisement
Quick Links
24" (61.0 CM) ELECTRIC SINGLE AND DOUBLE
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."
These words mean:
DANGER
WARNING
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
IMPORTANT:
Save for local electrical inspector's use.
W10045010
INSTALLATION INSTRUCTIONS
BUILT-IN OVEN
Table of Contents
BUILT-IN OVEN SAFETY .................................1
INSTALLATION REQUIREMENTS ..................2
Tools and Parts ..............................................2
Location Requirements..................................2
Electrical Requirements .................................4
INSTALLATION INSTRUCTIONS ....................4
Prepare Built-In Oven ....................................4
Remove Oven Trim ........................................4
Make Electrical Connection...........................5
Install Oven ....................................................7
Complete Installation .....................................8
BUILT-IN OVEN SAFETY
Your safety and the safety of others are very important.
You can be killed or seriously injured if you don't immediately
follow instructions.
You can be killed or seriously injured if you don't follow
instructions.
Advertisement
Table of Contents
Related Manuals for Whirlpool W10045010
Summary of Contents for Whirlpool W10045010
-
Page 1: Table Of Contents
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. IMPORTANT: Save for local electrical inspector's use. W10045010 BUILT-IN OVEN Table of Contents BUILT-IN OVEN SAFETY ...1 INSTALLATION REQUIREMENTS ...2... -
Page 2: Installation Requirements
INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools needed Phillips screwdriver Hand or electric drill (for wall cabinet installations) Measuring tape 1" (25 mm) drill bit Level (for wall cabinet installations) Parts needed... - Page 3 Single Oven Installed in Cabinet " (61 cm) min. cabinet width B. 1" (2.5 cm) top of cutout to bottom of upper cabinet door C. 32" (81.3 cm) bottom of cutout to floor D. 22 " (57.2 cm) cutout width E.
-
Page 4: Electrical Requirements
Electrical Requirements If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path and wire gauge are in accordance with local codes. Check with a qualified electrical installer if you are not sure the oven is properly grounded. -
Page 5: Make Electrical Connection
3. Grasp the edges of the oven door with both hands and close the oven door until it will no longer close. Lift and pull oven door toward you and remove. Set the oven door aside on a covered work surface. 4. - Page 6 4-Wire Cable from Home Power Supply IMPORTANT: Use the 4-wire cable from home power supply in the U.S. where local codes do not allow grounding through neutral, New Branch circuit installations (1996 NEC), mobile homes and recreational vehicles, new construction and in Canada.
-
Page 7: Install Oven
WARNING Excessive Weight Hazard Use two or more people to move and install oven. Failure to do so can result in back or other injury. 1. Using 2 or more people, lift oven partially into cabinet cutout. Use the oven opening as an area to grip. NOTE: Push against seal area of oven front frame when pushing oven into cabinet. -
Page 8: Complete Installation
“Assistance or Service” section of the Use and Care Guide or contact the dealer from whom you purchased your oven. W10045010 © 2007 Whirlpool Corporation. All rights reserved. 1. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.