Table of Contents
Advertisement
Before Using Your
Refrigerator
It is important to prepare your refrigerator for use.
This
section tells you how to clean it,
connect it to a power source, install it and level it.
Cleaning
your refrigerator
Removing
packaging
materials
NOTE:
Do not remove any permanent
Remove tape and any inside labels (except
instruction labels inside your refrigerator. Do
the model and serial number label) before
not remove the Tech Sheet fastened under
using the refrigerator.
the refrigerator at the front.
To remove any remaining glue:
Cleaning
it before
use
l
Rub briskly with thumb to make a ball, then
After removing all packaging materials,
remove.
clean your refrigerator before using it, if
OR
necessary. See cleaning instructions
on
l
Soak area with liquid hand-dishwashing
pages 16-l 7.
detergent before removing glue as de-
scribed above. Do not use sharp instru-
ments, rubbing alcohol, flammable fluids or
abrasive cleaners. These can
damage
the
material. See "Important Safety Instruc-
tions" on page 3.
Plugging
it in
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere
fused and properly grounded electrical
supply is required. It is recommended
that a
separate circuit serving only this appliance
be provided. Use a receptacle which cannot
be turned off with a switch or pull chain. Do
not use an extension cord.
See Electrical Requirements
and Ground-
ing Instructions
Sheet in your Literature
Package.
3-prong
grounding
type wall receptacle
\
Refrigerator
power cord
a-prong
grounding
plug
6
Advertisement
Table of Contents
