Table of Contents
Advertisement
Adjusting
the shelves.. .
1 First, remove food from shelf.
2 Slide shelf straight out to stop.
3. Lift front.
4.
Slide the rest of the way out
Replacing
Shelf:
I. Fit back of shelf on top of guides with wire stops
on the bottom of guides
2. Lift front, slide shelf in until it clears guide stops
Shelf Guide
Removing crispers and crisper cover.. .
Removing
the Crispers:
1 Slide crrsper straight out to stop, lift front, then slide
the rest of the way out
2. Replace
In the reverse order.
Removing
Cover:
1 Lift front and remove the cover support
2.
Lift
out cover by pulling up and out.
Replacing
Cover:
1. Fit back of cover into notch supports on walls of
refrigerator, then lower front into place
2 Replace
cover support with the long tab towards
the front Note: If support needs adjustment,
turn
base right to lower, or left to raise
Lift the Front and Pull Again.
Changing
the light bulb.. .
WARNING:
Before removing
the light bulb, either
unplug
the refrigerator
or disconnect
the electricity
leading
to the
re-
frigerator
at the main power
supply.
Shock
and injury
can occur
if elec-
tricity
remains
connected.
1 Reach behind control console to find bulb
2. Remove bulb.
3 Rep/ace wrth opphonce
bulb on/y
Automatic
ice maker.. .
Raise Signal
Arm to Stop Ice Maker.
Lower Signal
Arm to Start It
If you have the automatic
ice maker accessory
or
plan to add one later [Part No. ECKMF-831, there are a
few things you WIII want to know:
l
The ON /OFF lever is a wire srgnal arm
Down., .for making
Ice automatrcally,
Up...toshut
off the ice maker.
l
Shake the bin occasionally
to keep cubes sepa-
rated, and to obtain
increased
storage capacity.
l
It is normal for ice crescents
to be attached
by a
corner. They will break apart easily.
6
l
You will hear water
running
when ice maker
IS
working.
You'll hear ice fall into the bin Don't let
these sounds bother you.
l
The ice maker will not operate
until the freezer is
cold enough to make ice. This can take overnight.
l
Because
of new plumbing
connections,
the first
ice may be discolored
or off-flavored.
Discard the
first few batches
of ice.
l
If ice is not being made fast enough and more ice
is needed,
turn the Refrigerator
Control toward
a
higher number. Wait a day and, if necessary,
turn
the Freezer Control toward A.
l
If you remove
the Ice bin, raise the signal arm to
shut off the Ice maker. When you return the bin,
push it all the way In and lower the arm to the ON
posrtion.
l
If cubes are stored too long, they may develop
an
off-flavor...llke
stale water. Throw them away
They
will be replaced.
Cubes
in the ice bin can also
become
smaller by evaporation.
l
The ice maker water supply should
not be soft-
ened water. The chemicals
could damage
the ice
maker molds.
Advertisement
Table of Contents
