Advertisement
Changing the light bulb...
1. Reach behind
the control console
to find bulb
2. Remove
bulb.
3. Replace
with a 40-watt appliance
bulb.
Adjusting the refrigerator
shelves...
To remove
the shelf:
1. First, remove
food from shelf.
2. Slide shelf straight
out to stop.
GUIDE STOP.
3. Lift front, slide shelf the rest of the way out.
SHELF STOP
To replace
the shelf:
1. Fit back of shelf on top of guides
with wire stops
on the bottom
of guides.
2. Lift front, slide shelf in until it clears
guide
stops.
Removing crisper and crisper cover...
To remove
the crisper:
l
Slide crisper
straight out.
To remove
the cover:
1. Lift back, then slide to the rear until the front can
be lifted.
2. Lift cover up and out.
To replace
the cover:
1. Slide the front cover tabs into the back of the
front supports
on the refrigerator
walls.
2. Lower back
into place.
LIFT THE FRONT, THEN THE BACK.
GUIDE
OUT.
Ice cube trays...
h
I1 i i
For best results when freezing
ice cubes,
place
ice cube
trays side-by-side
in bottom
of freezer
compartment.
If cubes are not used, they may shrink. The longer
cubes
are stored, the smaller they get.
? EE':?both
ends.
2. Slightly twist.
Sounds you may hear...
Possible
Sounds:
Your new refrigerator
may
make
sounds
that your old one didn't
Because
the sounds are new to you, you might be concerned
about them.
Don't be. Most of the new sounds are normal.
Hard surfaces
like the floor,
walls and cabinets
can make the sounds seem louder.
The following
chart
describes
the kinds of sounds that might be new to
you, and what may be making
them.
Probable
Causes:
l
Wafer
Sounds:
When the refrigerator
stops running, you may hear gurgling
in the
tubing
for a few minutes after it stops.
l
Running
Sounds:
6
Your refrigerator
has a high-efficiency
compressor
and motor.
It will run longer than older designs.
It may even seem to run most
of the time.
Advertisement
