Advertisement
4. ASSEMBLY
REFER TO PARTS DIAGRAM BELOW (fig.1)
4.1.
Lay the sliding plate (8) onto the platform (1).
4.2.
Connect the oil hose coupler (29) to the port on the hydraulic pump (20).
4.3.
Connect air hose into the end of the air/manual pump (20).
4.4.
Attach the leading plate (9) to the end of the platform (1).
4.5.
Insert safety handle (36) through detent on rear end of lift and screw into thread on the bracket on the end of the safety wire (37).
4.6.
Tighten lock nut (35).
4.7.
FIT MOTORCYCLE WHEEL CLAMP
4.8.
Fit crank handle assembly (40) to platform (1) through pre-drilled holes, use bolt (5) washer (38) and nut (7).
4.8.1.
Fit moveable vice jaw (2) to crank handle assembly (40), use bolt (6).
4.8.2.
Fit fixed vice jaw (3) to platform (1), use bolt (5).
4.8.3.
Fit stop plate (4) to platform (1), use bolt (5).
4.9.
FIT SIDE EXTENSIONS
4.9.1.
Pass connecting bars (42) through front and rear holes in platform (1). Slide on side extensions (41).
4.9.2.
Secure at each end of the connecting bars (42) with position pins (44). Fit pin through hole on the end of the connecting bar and
secure with lock nut (34).
4.9.3.
Fit side extension ramp extensions (43).
Model illustrated: MT680.V4
fig.1
5. AIR SUPPLY
5.1.
You will require an air pressure of minimum 100psi, maximum 120psi to get the best
performance from this lift.
WARNING! Ensure the air supply does not exceed 120psi while operating the lift. Too
‰
high an air pressure and unclean air will shorten the product's life due to excessive wear,
and may be dangerous, causing possible damage and/or personal injury.
5.2.
Drain the air tank daily. Water in the air line will damage the lift.
5.3.
Clean the air inlet filter screen weekly.
5.4.
Keep the air hose between the compressor and the lift as short as possible, and install an
air filter and oiler, (fig 2).
5.5.
Line pressure should be increased to compensate for unusually long air hoses (over 8
metres). The minimum hose diameter should be 1/4" I.D. and fittings must have the same
inside dimensions.
5.6.
Keep hose away from heat, oil and sharp edges. Check hoses for wear, and make certain that all connections are secure.
© Jack Sealey Limited
Original Language Version
MC680A, MT680.V4 Issue:2 (3,9,F) - 29/05/19
fig.2
Advertisement
