Heatdryorairdry; Changing A Setting; To Add A Dish After Starting - Whirlpool DU8300XT Series Use & Care Manual

CYCLE CONTROL KNOB
RINSE & HOLD
For rinsing a few items to be
washed one or more days later.
Cycle time is about12 minutes.
Use AIR DRY only.
HEAT DRY or AIR DRY?
If the HEAT DRY Option is selected, air in the
dishwasher is heated during the "dry" part of
the cycle.
If the AIR DRY Option is selected, air in the
dishwasher is not heated. Using this option helps
save energy, but dishes ta ke longer to dry (over-
night) and some water spotting may result.
Some items [such as plastics] may need towel
drying.
For best results, use a liquid rinse aid such as
Jet-Dry?'
Changing a setting
You can change a setting anytime during any
cycle.
1. Lift up on the door latch to unlatch the door
and to stop the cycle. Don't open the door
until the spray arms stop spinning.
2. Turn the Cycle Control Knob clockwise to the
cycle you want.
3. Be sure the detergent dispensers are filled
properly for the new cycle.
4. Press door firmly to latch it. The dishwasher
will automatically start the new cycle.
To add a dish after starting
3.
1. To be sure the added item is washed and
rinsed, make sure the Cycle Control Knob
has not passed LIGHT WASH.
2. Lift up on the door latch to unlatch the door
and to stop the cycle. Don't open the door
until the spray arms stop spinning.
4.
5.
Open the door and add the dish.
Close the door. Do not latch it. Wait 30 sec-
onds for air in the dishwasher to warm up. This
helps reduce the amount of moisture that
can come from the vent when restarting the
cycle.
Press door firmly to latch it. The dishwasher
will automatically start where it stopped.