Approach Mode; Ground Mode - Garmin GTN 650 Series Pilot's Manual Upgrade Supplement

5. Touch the Use DEST APT key to automatically use the field
NOTE: Activating the Use DEST APT feature automatically uses the
elevation for the current destination airport for the TCAD. If no destination
airport is present in the GTN system, the TCAD will not receive a field
elevation and therefore not automatically enter approach mode.
En Route, Standard, or Terminal Shield Type
1. While viewing the TCAD Control menu, touch the Shield Type
Touch To Select
Shield Type:
Approach or
Standard
Touch To Manually
Set Shield Height
Figure 4-26 TCAD 9900BX Shield Setup for En Route, Standard, and Terminal
2. Touch the Shield Height key and use the keypad to select
3. Touch the Shield Range key and use the keypad to select
4.5.3.3

Approach Mode

1. While viewing the Traffic menu, touch the Approach key to
2. Touching the Approach key toggles Approach Mode between
4.5.3.4

Ground Mode

1. While viewing the Traffic menu, touch the Ground key to
2. Touching the Ground key toggles Ground Mode between On
GTN 650/750 Series SW V3.00 Upgrade Supplement 190- 01007-05 Rev A
elevation of the destination airport of the active flight plan for
traffic reporting.
key and touch the desired Shield Type: Enroute, Standard, or
Terminal.
the Shield Height value. The selected value will be shown in
the Shield Range key.
the Shield Range value. The selected value will be shown in
the Shield Range key.
activate Approach Mode TCAD traffic.
Set, Armed, or Active.
activate Ground Mode TCAD traffic.
and Off.
Touch To Shield Range
29