Table of Contents
Advertisement
•
Before first use, unpack the appliance and place all parts on a
horizontal surface.
•
Remove the jar assembly from the motor base & wash it in warm
soapy water. Use a nylon brush to clean the inside of the jar. Rinse
and dry thoroughly then return the jar to the motor unit.
•
TAKE GREAT CARE NEAR THE BLADES. THEY ARE VERY SHARP
•
It is a lot easier to clean if the jar is disassembled first. It is also a
great way to get to know your blender better!
•
Invert the jar unit onto a level surface, holding the jar handle, put
the the seal ring and blade assembly onto the jar base bottom and
secure the blade assembly by turning it anti-clockwise until tight
(See Fig.3)
•
Reposition the jar assembly with its opening upwards. Wrap the
other seal ring around the lid bottom and put the lid onto the jar
assembly. Place the measure cup exactly into the lid by ligning the
small projection on the both sides of the cup into the slots of the
lid and turning the cup clockwise until tight. (See Fig.4)
•
Finally, place the assembled jar onto the motor unit by aligning the
strip on the assembled jar bottom. (See Fig.5)
CAUTION: Jar and jar base is now secure. Do not try to twist the jar
and jar base onto motor unit. This is not necessary.
SP20180_IM.indd 5
HOW TO USE
5
12/04/2018 10:53
Advertisement
Table of Contents
