Advertisement
1. INTRODUCTION
Advanced White LED lighting provides superior efficacy, reduced glare, and even lighting output. These lighting
products are designed for indoor facility lighting, ranging from 15'-60' ceilings, such as industrial or retail applications.
A wide variety of lighting options, along with the WLL series' glass-free, long lifetime, dimmable design, make it a
great lighting solution in many different setting
Precautions
WARNING
Risk of electrical shock. Disconnect power before servicing or installing product.
Risque de choc électrique. Coupez l'alimentation avant l'entretien ou l'installation du produit.
WARNING
Risk of injury or damage. Unit will fall if not installed properly. Follow installation instructions.
Risque de blessures ou de dommages. Unité va tomber s'il n'est pas installé correctement. Suivez les instructions
d'installation.
CAUTION
Risk of injury. Wear safety glasses and gloves during installation and servicing.
Risque de blessure. Porter des lunettes de sécurité et des gants lors de l'installation et de l'entretien.
This luminaire is designed to be used in ambient temperatures of -40C to +45C (-40F to +113F) and be
mounted horizontally with the light source down as shown above. This luminaire should be installed
indoors. It should not be mounted in wet locations in which water can drip, splash, or flow into the
luminaire.
10/12/2015
No part of this publica�on may be reproduced without the prior agreement and wri�en permission of Horner Ligh�ng Group, LLC. Informa�on in this document is subject to change without no�ce.
ETG-WLL
White LED Linear High Bay and Low Bay Lighting
LED Linear Grow Lighting
LMAN0032-01-EN
ETG-WLL INSTALL SHEET
Page 1
Advertisement
Table of Contents
Related Manuals for HORNER ETG-WLL Series
Summary of Contents for HORNER ETG-WLL Series
- Page 1 It should not be mounted in wet locations in which water can drip, splash, or flow into the luminaire. Page 1 10/12/2015 No part of this publica�on may be reproduced without the prior agreement and wri�en permission of Horner Ligh�ng Group, LLC. Informa�on in this document is subject to change without no�ce.
- Page 2 Make sure to use set closest to center or closest to edge of bracket for level alignment. Page 2 10/12/2015 No part of this publica�on may be reproduced without the prior agreement and wri�en permission of Horner Ligh�ng Group, LLC. Informa�on in this document is subject to change without no�ce.
- Page 3 3) Gently slide outside edge down so that the reflector tab going into the fixture becomes flush against the housing. Page 3 10/12/2015 No part of this publica�on may be reproduced without the prior agreement and wri�en permission of Horner Ligh�ng Group, LLC. Informa�on in this document is subject to change without no�ce.
- Page 4 5) Remove protective coating from the reflector prior to powering on the light. Page 4 10/12/2015 No part of this publica�on may be reproduced without the prior agreement and wri�en permission of Horner Ligh�ng Group, LLC. Informa�on in this document is subject to change without no�ce.
- Page 5 Fax: 317 639-4279 Web: http://www.hornerlighting.com Email: techsppt@HornerETG.com Page 5 10/12/2015 No part of this publica�on may be reproduced without the prior agreement and wri�en permission of Horner Ligh�ng Group, LLC. Informa�on in this document is subject to change without no�ce.
Need help?
Do you have a question about the ETG-WLL Series and is the answer not in the manual?
Questions and answers