Reer FMC-B18 Quick Start Manual

Column for light curtains

GENERAL

These mounting instructions contain information about the correct mounting of the column.

The assembly of the FMC-B18 with the column rotation flange;



The assembly of the FMC-B18 stand for mounting on the FMC-CB/FMC-CBL stand bottom;



The correct mounting of the barrier on the column (rif. Normative ISO 13855 / EN999-2008);



Alignment Emitter - Receiver;



Please find detailed information about the function of the light curtains / light grids in the relevant

mounting and wiring instructions.

ASSEMBLY OF THE FMC-B18 WITH THE ROTATION FLANGE (Fig. 1)



Assembly the rotation flange with the profile using the correct provided screws (as shown in figure 1).

8540946 Rev.1

FMC-B18

COLUMN FOR LIGHT CURTAINS

Figure 1

www.reer.it

4/6

Table of Contents

Do you have a question about the FMC-B18 and is the answer not in the manual?

Page 1 The assembly of the FMC-B18 with the column rotation flange;   The assembly of the FMC-B18 stand for mounting on the FMC-CB/FMC-CBL stand bottom;  The correct mounting of the barrier on the column (rif. Normative ISO 13855 / EN999-2008);...
Page 2 ASSEMBLY OF THE FMC-B18 STAND WITH THE STAND BOTTOM; (Fig. 2)  Mount the FMC-CB/FMC-CBL stand bottom on the floor (see mounting instruction for stand bottom).  Loosen the three allen screws and remove the washers.  Assembly the column to the stand bottom, centering the FMC-B column rotation flange with the guides of the FMC-CB/FMC-CBL stand bottom upper plate.
Page 3 For an exact alignment of emitter and receiver, loosen the three allen screws (C) that fix the rotation flange and rotate the two columns until the barrier signal LEDS light on (ref. Technical manual). INSERT INSERT B = TILT C = ROTATION Figure 4 DIMENSIONS (Fig. 4) FMC-B18 FMC-B18 FMC-CB FMC-CBL Figure 5 8540946 Rev.1...