Advertisement
Quick Links
Advertisement
Related Manuals for Alert Labs Sumpie
Summary of Contents for Alert Labs Sumpie
- Page 1 SUMPIE Quick-start Guide...
- Page 2 ISED REGULATORY STATEMENT CAN ICES-3 (B)/NMB-3(B) This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence- exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
-
Page 3: What's Included
What’s Included Sumpie sensor 10W USB power adapter Antenna Antenna extension cable Mounting holster Phillips head screws (×3) Screw the antenna onto Sumpie’s side. - Page 4 The bottom of Sumpie needs to be able to see the water level in your sump pit. Snap the mounting holster onto to the pipe leading out of your sump pit. If the lid has a hole that Sumpie can see through, attach the mounting holster directly above the hole.
- Page 5 Sumpie is connected when the light turns green. This may take up to 5 minutes. NOTE: If Sumpie’s light is still red after 5 minutes, you may need to use the included antenna extension cable. See “USING THE EXTENSION CABLE” on page 11.
-
Page 6: Need Help
Need help? Take a photo of the installed Sumpie unit. You’ll need to upload the photo when you register the sensor. For additional help, visit alertlabs.com/support or contact us at help@alertlabs.com Sign-in at alertlabs.com or on the Alert Labs App. To register Add Sensor and use the serial number above. - Page 7 Slide Sumpie downwards onto the holster MOUNTING ALTERNATIVE 1 until it clicks into place. Fit Sumpie’s sensors into the two holes making sure they can clearly see the water in your sump pit, Detach the metal clip from the mounting holster. Use the without any obstructions.
-
Page 8: Drilling Template
Unscrew the antenna attached in Step 1. Screw the connector 1” 1” from one end of the extension cable onto Sumpie, and the other end onto the antenna. You will need to place and secure the antenna in an elevated location, away from metal structures (wires, pipes, beams, etc).
Need help?
Do you have a question about the Sumpie and is the answer not in the manual?
Questions and answers