Advertisement
Quick Links
Advertisement
Related Manuals for Alert Labs Sumpie
Summary of Contents for Alert Labs Sumpie
- Page 1 SUMPIE Quick-start Guide...
- Page 2 ISED REGULATORY STATEMENT CAN ICES-3 (B)/NMB-3(B) This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence- exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
-
Page 3: Ideal Installation
IDEALLY, SUMPIE WILL ALSO… Be mounted to the sump pump's pipe directly above the lid Have its antenna in a vertical orientation For information on how to install Sumpie, view the instructional video Ideal installation at alertlabs.com/SumpieInstall... -
Page 4: What's Included
What’s Included Sumpie sensor 10W USB power adapter Antenna Antenna extension cable Mounting holster Phillips head screws (×3) Screw the antenna onto Sumpie’s side. - Page 5 Rotate the metal bracket on the mounting holster 90° so that Snap the mounting holster onto to the sump pit's pipe. The bottom the opening faces to the side of Sumpie should be in line with the lid, or the top of the sump pit.
- Page 6 Slide Sumpie downwards onto the mounting holster until it clicks into place. Ensure that the sensors on the bottom of Sumpie are aimed directly at the water in your sump pit, and Connect Sumpie’s cord to the USB power adapter, and plug it in.
- Page 7 Take a photo of the installed Sumpie unit. You’ll need to upload the photo when you register the sensor. RED ..... No signal GREEN ...Good signal YELLOW ...On battery MAGENTA ..Updating OFF ....No power Sumpie is connected when the light turns green. This may take Sign up or log in at app.alertlabs.com.
-
Page 8: Troubleshooting
ISSUE PAGE I can't clamp Sumpie to the pipe and have a clear view of the water level Page 11 └ My sump pit has a lid with a hole Page 11 └ My sump pit does not have a lid... - Page 9 The included screws to mount the base of the holster to a wooden beam or other support you might lay across the sump pit. top of Sumpie should be in line with the lid of the sump pit.
-
Page 10: Need Help
SUMPIE CANNOT ESTABLISH A CELLULAR CONNECTION If after 5 minutes of being on, the light on Sumpie is still blink- ing red, you may need to use the antenna extension cable. Unscrew the antenna. Screw the connector from one end of the extension cable onto Sumpie, and the other end onto the antenna.
Need help?
Do you have a question about the Sumpie and is the answer not in the manual?
Questions and answers