Breezair IWC 10 Installation & Operation Manual page 6

SETTING THE CLOCK
IMPORTANT Please read the application notes before programming this controller. !
When the Wall Control is first installed, it will show four flashing clock digits. Set the clock on the
Wall Control before proceeding with any other programming. Programming can only be done with
the Wall Control switched OFF.
1/ Hold the button down for over 3 seconds, until the
PROG
2/ Press the button to accept. Four digits will show with the first digit flashing (Fig 14).
AUTO
3/ Use the and
for each digit to set the 24-hour time. The
4/ Use the and
enter the OFF mode. While the cooler is OFF it will display the current time and day.
Note: After replacing the battery reset the clock time.
TURNING THE COOLER ON
The Wall Control can be switched ON and OFF by pressing the
remember the setting from when the cooler was last used.
PREPARING TO START
Whenever you select AUTO mode or COOL in MANUAL mode, the cooler will take a few minutes
to start as it fills with water and saturates the cooling pads. This time will be decreased if the tank is
full or the cooler has only recently been turned OFF. During this time the
will flash on the display (Fig 16).
MANUAL MODE
With the Wall Control switched ON, press the
(Fig 17).
You may then press the
being delivered but not cooled).
When COOL or VENT has been selected, the Wall Control will maintain a constant fan speed as
shown by the bar graph on the display.
To increase or decrease the fan speed, press either the
AUTO MODE
To select the AUTO mode press the
In AUTO mode the cooler will remember the last setting used and try to achieve this setting.
Operation may vary depending on ambient conditions. Pressing the
no effect when the cooler is in AUTO mode. (See Temperature Control Program on the following
page).
buttons to change the first digit and the
M (Monday) symbol will then start flashing (Fig 15).
buttons to change the day of the week and press the
AUTO
button to switch between COOL
COOL
button until
AUTO
symbol flashes.
button to enter. Repeat this
AUTO
button. The Wall Control will
button until Man is shown on the display
and VENT
or button.
Auto is shown on the display (Fig 18).
and
1
Getting Started
14
15
button again to
AUTO
16
and Start: symbols
(where fresh air is
17
buttons will have
18
5
M
Man
Start:
Man
Auto