Bass Pro Shops 8 Rod Standing Rack Owner's Manual page 3

3. Locate the lower notched cross piece (I), 1 screw (E), 1 wood peg (H), and 1 screw receiver (F). Using the
same upright piece from step 1, orient part I so that the notches are facing toward the logo and the
screw receiver holes are on the bottom side. Insert a screw receiver into the hole oriented toward the
end that matches the upright connection with part D. Make sure that the threaded opening in the
receiver is aligned with the hole exiting the end of the piece. Insert wood peg (H) into the
front/non-through hole on the inside of upright A. Find the correct corresponding hole on the upright
piece, indicated in the image. Insert a screw through the hole on the upright, then into the end hole of
part I so that the screw can be threaded into the screw receiver. Use the screwdriver to tighten the screw
snugly.
B
D
I
F
H
A
E