GE Lumination LUR Series Installation Manual page 5

NOTE: The following brackets use a locking mechanism.
NOTE: All with tombstones come with one drilling screw. All brackets without tombstones come with two drilling
screws. brackets
7A
Stationary
tombstone
7C
7
BRACKETS (A) OR (B) OR (C): Rotate the locking mechanism(s) on each bracket to the unlocked position as shown.
8
BRACKET (A): In the unlocked position, check if the pins from both locking mechanisms can slide into the slots
in the fixture's tombstones at the same time (left). If they are not aligned, press down on the tabs and slide the
mechanism left or right to match the distance between the tombstones (left). Check alignment and repeat until
correct alignment found. Move locking mechanisms on all brackets to the same position before proceeding to
next step.
NOTE: The locking mechanism must be aligned on the bracket as shown (right).
Adjustable
tombstone
Press down on both
tabs at the same time
5
7B
Good
Alignment
Bad
Alignment