Kity PV 6000 Translation From The Original Instruction Manual page 33

For faults that are not listed below, please contact the customer service of Scheppach.
Problem
The hydraulic pump will not
start
The cleaver column does
not move in
Motor starts, but cleaver
column does not move in
Maintenance and repairs
All maintenance work should be carried out by qualified personnel in strict compliance with the present operating instruc-
tions. Before any maintenance work, all the possible precautions measures must be met; switch off the machine and interrupt
the power supply (if necessary, unplug the connector). Affix a label to the machine, which explains the breakdown: "machine
out of commission for maintenance: Unauthorized persons may not stay in the vicinity of the machine and put it into opera-
tion. "
m Troubleshooting plan
Possible cause
No voltage
The thermal switch of the
motor has switched off
Low oil level
One of the levers is not
attached
Dirt in the guide rails
Motor turns in wrong
direction
Remedy
Check whether the lines are
supplied with current
Restart the thermal switch
inside the motor housing
Check the oil level and add
more oil if necessary
Check the attachment of
the levers
Clean the cleaver column
Check the motor direction
and adjust it if necessary
Hazard classification
Risk of electric shock
This operation must
be carried out by a
maintenance electrician.
Danger of contamination
This operation can be
carried out by the machine
operator.
Cut danger
This operation can be
carried out by the machine
operator.
33