Whirlpool RC8100XA Use And Care Manual page 10

CA R I N G F OR YO UR CO OK TOP
4. Lift out the reflector bowl. See "Cleaning
chart" on page 11 for cleaning instruc-
tions.
Replacing
1. Make sure all control knobs are turned
off and cool before replacing surface units
and reflector bowls.
2. Line up openings in the reflector bowl
with the surface unit receptacle.
3. Hold the surface unit as level as possible
with the terminal just started into the
receptacle. Push the surface unit terminal
into the receptacle.
4. When the terminal is pushed into the
receptacle as far as it will go, the surface
unit will fit into the reflector bowl.
NOTE: Reflector bowls reflect heat back to the
utensils on the surface units. They also help
catch spills. When they are kept clean, they
reflect heat better and look new longer.
If a reflector bowl gets discolored, some of
the utensils may not be flat enough, or some
may be too large for the surface unit. In either
case, some of the heat that's meant to go into
or around a utensil goes down and heats the
reflector bowl. This extra heat can discolor it.
10