Advertisement
Quick Links
Advertisement
Related Manuals for NookBox KP-35
Summary of Contents for NookBox KP-35
- Page 1 NookBox Installation Guide Remote Keypad KP-35 Installation Guide Remote Keypad (KP-35)
-
Page 2: Remote Keypad
NookBox Installation Guide Remote Keypad KP-35 Remote Keypad (KP-35) KP-35ZBS is a ZigBee Remote Keypad. It is designed to have quick access control of the ZigBee network coordinator or system control panel. The Keypad can send wireless signals to and receive wireless signals from the coordinator in the ZigBee network. The LCD display will display any information the ZigBee network coordinator or system control panel sends back. -
Page 3: Identifying The Parts
NookBox Installation Guide Remote Keypad KP-35 Identifying the parts 1. Backlit LCD Display 2. Green LED -OFF: in stand-by mode -ON: when any key is pressed to wake up the Remote Keypad 3. Yellow LED -The Yellow LED will flash once every 3 seconds when any fault situation is detected, and turn to OFF when all fault conditions are restored. - Page 4 NookBox Installation Guide Remote Keypad KP-35 Features Battery and Low Battery Detection • The Remote keypad uses three CR123 3V Lithium batteries as its power source. • The Keypad will detect battery status. If the battery voltage is low, a Low Battery signal will be sent to the ZigBee network coordinator or system control panel.
- Page 5 NookBox Installation Guide Remote Keypad KP-35 Removing Device from ZigBee Network To remove the Keypad from current ZigBee network, the Keypad must be put to Factory Reset to complete device removal. Factory Reset function will clear the Keypad of its stored setting information and prompt the Keypad to search for new ZigBee network.
- Page 6 NookBox Installation Guide Remote Keypad KP-35 Beep Control: Entry/Exit Beep: Set to “Turn On” or “Turn Off” this function to program whether the Keypad should emit warning beeps during Entry Delay or Exit Delay timer. Alarm Beep: Set to “Turn On” or “Turn Off” this function to program whether the Keypad should emit warning beeps when an alarm is...
- Page 7 NookBox Installation Guide Remote Keypad KP-35 Change of Battery • Put the Control Panel to programming menu to bypass the KP tamper alarm. • Dismount the Remote keypad. • Take out the old battery and press any key to discharge before replacing the new battery in the battery compartment, with unmarked (negative) side of battery facing down.
- Page 8 NookBox Installation Guide Remote Keypad KP-35...
- Page 9 NookBox Installation Guide Remote Keypad KP-35 For more information visit: www.getnookbox.com...