Related Manuals for NookBox P119010
Summary of Contents for NookBox P119010
- Page 1 NookBox Installation Guide Keypad Installation Guide NookBox Keypad (P119010 / E6309744)
- Page 2 NookBox Installation Guide Keypad NookBox Keypad (P119010 / E6309744)
-
Page 3: Parts Identification
NookBox Installation Guide Keypad Parts Identification 1. Active LED 10. Dual Key Learning Press both # and • keys together to send learn Code 2. Status LED 11. Medical Alarm (if enabled) 3. Fault Display LED • press both 7 and 9 to trigger medical alarm Arm Key 12. -
Page 4: Led Indicator
NookBox Installation Guide Keypad LED Indicator Active LED (Blue/Amber) • Blue LED on 5 seconds: the system is in Normal Operation Mode. Blue LED flashes for 5 seconds: low battery in Normal Operation Mode. • • Amber LED on: the system is in Test Mode. -
Page 5: Power Saving Feature
NookBox Installation Guide Keypad Power • Remote keypad uses one CR2 3V Lithium battery as its power source. • Remote keypad can also detect the battery status. If the battery voltage is low, the Active LED will flash (Amber in Test mode or Blue in Normal mode) during operation. -
Page 6: Installation Procedures
NookBox Installation Guide Keypad Installation Procedures Step 1. Put the Control panel into learning mode. Step 2. Adding remote keypad into the Control Panel: Test Mode Learning: Put remote keypad in Test mode by entering KP PIN code (default: 0000), then press key. - Page 7 NookBox Installation Guide Keypad Mounting Remote Keypad To mount the remote keypad: Remove the front cover. 2. Using the 2 mounting holes of the back cover as a template, mark off the positions in the most appropriate place. 3. Insert the wall plugs if fixing into plaster or brick surface.
-
Page 8: General Operation
NookBox Installation Guide Keypad Dual-key Alarm function » Panic Alarm — Press both 1 and 3 keys to trigger Panic alarm. » Fire Alarm — Press both 4 and 6 keys to trigger Fire alarm. » Medical Alarm — Press both 7 and 9 keys to trigger Medical alarm. -
Page 9: Factory Reset
NookBox Installation Guide Keypad Fault Conditions When Remote Keypad is under NORMAL OPERATION MODE, a) When fault condition exists within Control Panel, if the Keypad is used to arm the panel, the keypad Status Blue and Fault Amber LED will flash 4 times along with 3 beeps to indicate fault condition. - Page 10 NookBox Installation Guide Keypad For more information visit: www.getnookbox.com...