LG LN54 Series Installation Manual page 6

6
INSTALLATION MENU
(11) DTV Channel Update
y It is a mode to set whether to update dtv channel automatically or not.
When DTV Channel Update is set to 'Auto', the function to update TV's programme map according to DTV
programme's stream information.
DTV Channel Update is set to 'Manual', the function to keep TV's programme map even though DTV programme's
information is changed.
(12) Power On Default
y Set the channel to display and Volume Level, etc. when turn on power in AC Power On or Stand-by status.
y Set to Yes(Work) or No(Do Not Work).
y When 'Power On Default' is set to No, it is not applied to the subordinate Programme, Volume, A/V Setting menu.
y When Power On Default is set to Yes, it can set by entering the subordinate menu.
(12-1) Input Source
y Set whether it is turned on by the set input source or by the last stored input source.
y It is turned on by the Last Memory Input if the Input source is turned off.
y It is turned on by the Last Pr. If the Input source is turned off and the Last Memory Input is the RF.
y All sources supported by the said model can be set as Input source. (The Input source value should be rotated.)
y If both the Input source and the ON TIME are set, the Input source takes the priority.
y If the DTV/Radio Channel does not exist at the map, the DTV/Radio is skipped while navigating.
y When the Input source is changed to the DTV/Radio, the Programme No. is set to the first programme of the
Channel map of the DTV/Radio.
y When the Input source is changed to the ATV, the Programme No. is set to 0. (If the channel map structure does
not support this, it follows the structure of the said model.)
(12-2) Programme
y If the Input source is DTV or ATV, the set programme is played when the power is turned on.
y Only when the Input source is DTV or ATV, it can be entered into the Programme item.
y When the Input source is turned off, the Last input at the time of the power-off is turned on, and when the Last
input is the RF, the Last programme is played.
y If the Input source is the DTV, the programme number existing at the programme table can be selected.
y If the Input source is the ATV, 0~(MAX_PR – 1) can be selected. (If the channel map structure does not support
this, it follows the structure of the said model.)
y The programme should be rotated.
y If both the programme and the ON TIME are set, the programme takes the priority.
(12-3) Volume
y If both 'Volume' data and 'On Time' is set, but just the value is different, then 'Volume' has priority.
y This sets whether to apply the Volume Level or not when the power is turned on.
y When both the Volume and ON TIME Volume are set and have different values, the Volume Level value is set as
the ON TIME Volume value, and cannot move to the ON TIME Volume item.
y The next value for the max volume is OFF. And next it will be changed to 0.
(12-4) A/V Setting
y Set to Yes(Work) or No(Do Not Work).
y If 'A/V Setting' is changed from No to Yes, parameters that are set before entering Installation Menu are applied
whenever turn on power.
y Following Parameters are applied to basic.
- Picture section - PSM mode, Picture Data (Contrast, Brightness, Colour, Sharpness, Tint)
- Sound section - SSM mode, Sound Data (Balance, Equalizer Data) and AVL and Language, Teletext language,
ARC Data.
Except these, other Parameters are applied differently according to the TVSet.