Fault Codes - P.Lindberg ZF-50 Original Manual

Fault codes

Fault Possible cause
code
E1
- Not enough oil
- Faulty photo cell
- Insufficient combustion
- Clogged fuel filter
- Ignition fault
E2 Temperature gauge
- Poor connection or faulty
sensor
LO Temperature has fallen below
o
-9 C
HI Temperature has exceeded 50
Lamp Operating failure
flashing
P. Lindberg A/S
Tel.: +45 70 21 26 26
Possible solutions
- Fill with oil
- Check and replace photo cell if
necessary.
- Make sure you use the
recommended fuel.
- Clean or replace filter.
- Check the wires. Replace ignition if
necessary.
- Check connection
- Replace sensor
This is normal
o C This is normal
Check equipment and restart.
20
Sdr. Ringvej 1
DK-6600 Vejen
MAN 9058634 EN V1
www.p-lindberg.dk
e-mail: salg@p-lindberg.dk