Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Heatport H2 DiGI Start Pro
Summary of Contents for Heatport H2 DiGI Start Pro
- Page 1 Heatport H2 / H4 - DiGI Start Pro INSTRUCTIONS...
- Page 2 Note: The Wireless Controller is only an additional accessory for controlling the heater and the Wired Switch can work fully without the Wireless Controller. The temperature sensor is integrated inside the Wired Switch. Wake Up of Wired Switch In the OFF state,the LCD display of the Wired Switch is OFF. To wake up the display, short press the POWER button on the Wired Switch.
- Page 3 Manual Fuel Filling Mode This mode is used after the first installation of the unit or if the unit shuts down because the fuel tank ran out of the diesel and the display shows error code E-10. This mode is not available if the unit was previously running with successful shutdown.
- Page 4 Startup Once the LCD of the Wired Switch is ON, long press the POWER button of the Wired Switch OR Wireless Controller for 3 seconds until the top line of the LCD display starts flashing “oN”. The unit will start pre-heating and once it reaches the required temperature, the fuel pump will start pumping fuel.
Need help?
Do you have a question about the H2 DiGI Start Pro and is the answer not in the manual?
Questions and answers