Advertisement
7) Set front panel POWER switch in the ON position (down position, with adjacent
STANDBY switch in the "STANDBY" mode) for 60 seconds to allow tube filaments to
warm up. Select the Rectifier to be in SS (Solid State) mode first.
8) Set front panel STANDBY switch to "ON" mode (down position)
9) ROCK!!!!!!
3) FRONT PANEL CONTROLS
From left to right:
1) POWER 2-way toggle switch
2) STANDBY 2-way toggle switch
3) RECTIFIER 2-way toggle switch
4) INDICATOR LED
5) POST PHASE INVERTER MASTER VOLUME (PPIMV) control
6) PRESENCE control
7) CHARACTER 2-way toggle switch
8) BASS control
9) BOOST 3-way toggle switch
10) MIDDLE control
11) V2A 2-way toggle switch
12) TREBLE control
13) V1B 2-way toggle switch
14) VOLUME I control
15) BRIGHT 3-way toggle switch
16) VOLUME II control
a. With Push Pull JUMPER switch
17) INPUT I and II input ¼" instrument jack
POWER two-way toggle switch powers the amp on and off. With the toggle switch in the
DOWN ("ON") position, the amp is on. In the UP position, the amp is OFF.
Advertisement
