Fluff Air Setting; Finish Guard Control; Drying Times; Mixed Loads - Whirlpool LE7800XM Use & Care Manual

The dryer does not heat when the
Temperature Selector is set on FLUFF
AIR. This setting can be used to fluff
bedding, plastic tablecloths, foam
rubber pillows,stuffed toyssneakers.
etc.
1. Turn the Temperature Selector to
FLUFF AIR.
2. Turn the Control Knob to the num-
ber of minutes you want in the
TIMED DRYING Cycle.
3. Push the START Button
Tl'MHLE PHESS'i Setting
The TUMBLE PRESS setting removes
wrinkles from dry clothing.
1.
Set Control Knob to TUMBLE PRESS.
2. Set Temperature Selector to PERM'T
PRESS/MED.
3. Push START Button,
The load will tumble in heated air
for 5 minutes. The heat shuts off and
the dryer continues to tumble the
load for 10 more minutes.
for best results, TUMBLE PRESS only
a few items at a time. Put them on
hangers or fold them as soon as the
dryer stops.
FINISII G1~.\RD Control
When you are not able to unload
the dryer as soon as It stops, wrinkles
can form
If you don't open the door wrthrn 5
mrnutes atter the dryer stops, FINISH
GUARD takes over automatically
to protect the load You don't have
tosei the Control Knob for FINISH
GUARD.
FINISH GUARD tumbles the load,
without heat, every 5 minutes for up
to 40 minutes. This tumbling rear-
ranges and fluffs the load to help
avoid the wrinkles that set in when
the load remains in the warm dryer.
Drying times
Drying times WIII vary depending on
l
amount of moisture in the clothes.
. type and weight of the fabric.
l
size of the load
l
room temperature around the
dryer.
l
temperature of the wash rinse
water.
l
amount of lint in the lint screen.
l
dryer temperature selection
See page 6 in your "Dryer Gurde"
for more information.
Mixed loads
When drying a load with different
kinds and weights of fabrics, use the
cycle suggested for the lightest
fabrics. When the dryer stops, remove
dry items and reset the control. 7