Advertisement
7. Cleaning
For daily cleaning, we recommend wiping with surface disinfection (wet wipes), either with anti-
bacterial ingredients (according to SSI guidelines) or with alcohol.
•
For a thorough cleaning, it is possible to wash the shower chair in an automatic washing
machine or with saturated water vapor for up to 1 minute at 90 ° C, up to 5 minutes at 85 ° C
or up to 10 minutes at 80 ° C.
•
Easy cleaning of and under the toilet seat. To remove the seat, see section 6.4 removing the
seat. Both frame and seat can then be cleaned.
•
Depending on the hardness of the water where you live, we recommend removing lime
regularly. Do not use acid or similar. Spray the chair with tartaric acid (1:1) or household
vinegar, leave for 2-3 hours and rinse with water. Wipe the chair with a dry cloth. In extreme
cases, it may be necessary to use lime remover. In this case, the minimum should be diluted
1-4 with water before applying the limed areas to the chair.
The product is usually maintenance-free, but you should periodically undergo a check that by a
professional.
Warning!
When using the chair under very calcareous water, a lime bond on wheel bearings and other moving
parts may occur. In this case, it can be cleaned with a lime-dissolving agent and then lubricated with
lubricating oil.
Warning!
When used in very chlorine-containing environments, extra strong corrosion will occur and the
warranty will end.
7.1. Maintenance
•
Clean the metal parts with a soft, damp cloth / sponge. Wipe the parts immediately after
cleaning.
•
All moving joints should be lubricated every six months or when it "creaks" or any other
noise occurs. In particular:
-
-
-
•
We recommend using all available lubricants. Protect padded parts from contact with
lubricants and remove any excess or leakage of them with a dry cloth.
•
Check thread collections regularly, or at least every six months. Such collections are
especially:
-
-
-
•
If there are loose connections that cannot be solved, take the chair out of use and contact
your dealer for service.
Rev. 02-20
Wheel axle,
Shaft Actuators,
Moving parts
Bolts welding with upper and lower frame;
Wheel screws,
Armrest screws.
Page 7/9
User manual - Shower Chair 2018
Advertisement
