Advertisement
5. Assembly description
As shown on the picture above the device can be assembled in quite an instinctive way. We
recommend that you follow the below steps:
Take all the content out of the box and check with the list above that everything is there. If
you discover that some parts are missing or damaged, do not continue the assembly process.
Contact your dealer right away.
Put the main frame upside down on the floor. You'll see four holes at the end of the vertical
frame tubes.
Insert the wheel assembly tubes into each frame bottom ending.
There are 2 holes (A & B) drilled in both: the chair's frame and each
wheel's assembly (as shown on the picture). Adjust the wheel's
vertical tube to the position, where one of its holes would match one
of the holes in the frame. Due to this solution it is possible to set the
seat height of the chair in 3 different heights (in 2,5 cm steps). When
required position is reached insert the fixing bolt through all the holes
and tie it with the nut from the opposite side of the tube. Always
adjust all 4 wheels to the same height. Check if all the wheels are
locked correctly by pulling them upwards. They should not be able to
slide out or shake.
Now turn the main frame around into its correct position so it would stand on the 4 wheels.
Before further assembly, lock all brakes on the 4 wheels, so the device won't move.
Now slide the back frame tubes endings in to two assembly holes located in the rear, top part
of the main frame. Tighten the bolts on both sides of the frame, so the back is stable and rigid.
Put the lid on the bucket. Slide it in to the rails located under the seat. You should do it from
the front into the rear direction of the chair. When the bucket is in the place cover the middle
hole of the seat with the PU cover.
Now you can attach the footrests. Put the top of the footrests into the hole located at the top
front end of the main frame. The footrest should be directed outwards at that point. Now turn
the footrest in until it will lock in its front position. Repeat the same procedure for the second
footrest.
6. Function description
To engage the brakes step down with your toes on the pedals attached to the rear part of each
wheel until they are locked. To disengage the brakes pull up the pedals with your toes until
they will unlock.
You should always engage the breaks when you don´t plan to move the chair. Never leave the
chair without breaks engaged when there is someone sitting in it! Never leave chair on
slopes without breaks engaged!
You can adjust the length of the footrests to match the height of the user. Release the leg rests
length adjustment bolt and slide the footrest tube in to the required position. Then tie the bolt
so the footrest is fixed and stable.
The excrements bucket should only be used by persons who have difficulties to use regular
toilets. For the bucket to be used remove the middle whole cover. Take the lid off the bucket.
When defecation is finished put the lid back on the bucket and pull the bucket out of the
chair. Empty the bucket, and wash it before sliding it back under the chairs seat. Put the seats
middle whole cover of the seat back on.
Never leave bucket unemptied or unwashed.
To unlock and detach the footrest press the locking lever, turn the footrest outwards and then
pull it up, of the chair. The elevating foot plates and the above function helps to transfer the
Rev. 02-20
Page 4/9
User manual - Shower Chair 2018
Advertisement
