Table of Contents
Advertisement
Renlove~8
before opedng top
WIredIp-
holda dooi
lfyowchywbgasandhasafullfront
panesranoveffontpm3lasfolkurs:
1. Unplug the power supply cord or turn
off the electrical power.
2. Cpen lint screen lid. Remove two
screws in lint screen area.
3. Cpen top by pulling forward and up
at each front corner (see view A).
Rest raised top against wall behind
dryer (top is hinged at rear).
Remove two internal screws from
front panel flanges (near top front
comers). Lift front panel slightly.
lifting off bwer dips (see view B).
4.
5.
6.
7.
Sbtily pull front panel forward,
disengaging panel from drum. (Drum
will drop slightly.)
Move front panel aside and rest edge
against side of dryer. Avoid discon-
necting wire clips (see view C) or
damaging wires.
Remove lint from area shown in -gas
dryer illustratbn on page 10 with soft
brush or vacuum deaner. Avoid
damaging wires, funnel or igniter.
Reassemble in reverse order. Before
cbsing the top, check the following:
- Drum seal must be flared out (see
view D) and properly positioned
against panel at back of drum.
Rotate drum countercbckwise one
full turn to chedc drum seal.
- Belt should be centered and tight
on dryer drum.
8.
- wire clips which hold the door
switch wires must be anchored in
slot in top of front panel (see
k
view C) and along top edge of side
panel. Door wires must not touch
drum when dryer is operating.
See Warnlng, page 10.
Replace top panel and lint screen
screws. Top and front panels must
be securely in place before operating
dryer.
9. Reconnect power and level dryer
again (if necessary).
NOTE: Call Consumer Assistance at
1-800-253-l 301 for assistance or
more information.
11
Advertisement
Table of Contents
