Advanced Installer Menu - ComfortNET CTK02AA Installation Manual

Advanced Installer Menu

This menu allows the installer to check installer-specific information or set advanced settings. It is accessible from the
Home screen when the
Select the items using the
settings. Press Enter button to save any changes and display the previous menu or press Home to display the Home
Screen. If 2 minutes pass without any buttons pressed, the Home Screen will return and changes will not be saved.
Items on the Advanced Installer Menu are:
Communicating Devices
■
Fault Status
■
USB Upload
■
Heat Pump Disable*
■
*Items marked with * may or may not appear in the list depending on the configuration of the system.
Communicating Devices: This menu item will list each piece of system equipment connected to the ComfortNet
network. The equipment can be selected and entered to view identifying information, operating information and setup
status as described in Equipment User Menus.
Fault Status: This menu item lists current equipment fault conditions.
The system equipment experiencing the fault will be listed with details of
the fault. If no faults are detected, this screen will show nothing.
USB Upload: The USB load menu displays a list of thermostat parameters that
can be loaded to the thermostat from a USB memory device. If the USB port
detects a USB memory device, this menu will automatically display.
Contractors can download the template at www.comfortnet1.com.
In the USB Upload menu, select the item to upload and press
mark the item with a red box. After all items to upload are selected,
press the Upload button.
ComfortNet HiDef Control System
and buttons are pressed at the same time for three seconds.
or buttons and press the
Air Handler Lockout*
■
Dual Fuel Setpoint: 5°*
■
Heat Cycle Rate: Medium
■
Cool Cycle Rate: Medium
■
button to enter the item to view information or change
to
TM
Installation Guide / 11