Ayce Z1C-DW-32M3 Original Instruction Manual page 77

CAUTION: Do not overfill the gearbox with grease. If you are not sure how to top up the
grease, please take your product to the nearest authorized service centre for this to be
done.
h. Switch on and off (Fig.8)
Fig.8
3. Operation for working
NOTE: The tool is equipped with an anti-vibration back handle for additional comfort,
easy control and to reduce user fatigue.
a. Selecting the required function (Fig.9)
!
Do not attempt to change the position of the selectors when the motor
is running. Doing this will cause serious damage to the tool and
possible injury to the operator.
WARNING
Fig.9
• Switching on: Press the on/ off trigger
switch.
• Switching off: Release the on/off
trigger switch.
It is possible to use the hammer drill in
three different modes.
• DRILLING MODE
Turn the mode selector switch 1 to
Fig(b), and turn mode selector switch
2 to direction Fig( c).Select this mode
for drilling into wood, plastic and metal
products - can be used with the key chuck
• HAMMER DRILLING MODE
Turn the mode selector switch 1 to Fig(a)
,and turn mode selector switch 2 to the
direction Fig(c).Select this mode for
drilling into brick, concrete and masonry
products - - must NOT be used with the
key chuck
• CHISELING MODE
GB
76 | 77