Pelonis PSH700S Owner's Manual page 4

OPERATING INSTRUCTIONS
（Heat）LOW
OFF
（Fan）LOW
（Heat)HIGH
（Fan）HIGH
Power selection knob
Pilot light
DO NOT COVER
Safty grille
Step.1.
● Check before turning on the machine
1. Check if the power wire is under good condition.
2. The product adopts 120V 60Hz AC power supply, before using, please confirm if the rated current
of the power socket meets the local requirements with safe grounding device, otherwise, please
replace it with the qualified socket.
Step.2.
● Put the machine on the flat place
Uneven place may possibly cause the tip-over switch at abnormal position, then the fan heater
can't work after turning on, therefore, please put the fan heater on the flat place, at least the surface
below the base of the fan heater must be flat.
Step.3.
● Plug in the fan heater
Plug the fan heater directly into a wall outlet/receptacle, fit only one way in a polarized outlet, match
wide blade of plug to wide slot and fully insert, if the plug does not fit fully in the outlet, reverse the
plug and try again. Never use the fan heater with an extension cord or reloadable power tap (outlet/
power strip).
Step.4.
● Turn on the fan heater and select modes
Turn the Power selection knob to select 4 functions: (Heat) 1500W High, (Heat) 900W Low, (Fan)
High, (Fan) Low.
Step.5.
● Turn off the fan heater
A. Turn the Power Switch Knob to 0 position.
B. Remove the power plug, store the fan heater after the entire machine has become cool.
3