Whirlpool Coolerator CAW21D2A1 Installation & Operation Manual page 11

16
. Install window rail seal and window lock
bracket and drain cup. Press foam meeting rail
seal into place and cut to proper length (see
Figure 17.) Make a mark and drill a l/8" pilot
hole, then install lock bracket using wood
screw.
Seal small openings around installation with
gum-type sealer.
Figure 17
n
ABINET RAIL
SLOT.
17
l
Apply seal strip to top of unit flange as shown
in figure 18. Plug two crating bolt holes (l/4"
diameter with gum sealer to prevent water
dripping from these holes (see Figure 18.)
Figure 18
CRATING
BOLT HOLE
NOTE: During high
humidity, condensate
may drip from the
outside of your air
conditioner onto the
ground below. If your
air conditioner is installed
where this Is undesirable,
you can direct the water
to a more suitable spot
by using some flashing
or other similar means.
DRAIN CUP ASSEMBLY
INSERT INTO
18
l
Insert air conditioner into cabinet. Slide air
conditioner only three-fourths of the way
into the cabinet. Do not push against sharp
fins and plastic parts. Apply 5/8"-thick seal
strip onto bottom of base of air conditioner
as shown in Figure 19. Now push air condi-
tioner all the way into cabinet being sure
angle bracket on base clears bottom front
edge of cabinet. Again, do not push against
sharp fins and plastic parts. Attach green
ground wire to the left-front corner of unit
base by using ground wire screw (see Figure
19).
Figure 19
FLANGE SEAL
GROUND
WIRE
ANGLE BRACKET
ON BASE
19
l
Attach front panel by placing bottom edge on
clips and pushing top down, then in and up.