Whirlpool Coolerator CAW21D2A1 Installation & Operation Manual page 10

11
l
Lower window and level air conditioner.
Lower the window firmly behind window
gasket. Leveling the cabinet is not required in
a normal installation since the proper slope is
designed into the product. However, be sure
you have approximately a one-half bubble
(5/8") downward tilt to the outside for
proper water drainage. If necessary, reposition
or shim cabinet to provide the proper tilt or
side-to-side leveling. Now, tighten all four
filler board screws. Be sure cabinet bottom
flange is against rear of window sill for proper
seal. Finally, make two l/8" pilot holes into
the window sill, using the holes in the cabinet
as a guide (see Figure 13). Use two wood
screws to secure the bottom of the cabinet to
the window sill.
12
. Construct outside support assemblies by
fastening vertical and angle supports together
with 3/4" bolts, washers and nuts. Tighten
securely (see Figure 14).
PLAIN WASHER
FASTEN BOLT
SECURELY
13
l
Position support assemblies against bottom
rail of cabinet and slide toward house, allowing
approximately one-inch clearance between
end of angle support and wall (see Figure 15).
Select proper sets of square holes in cabinet
rails and fasten support assemblies to cabinet
rails by using 3/4" bolts, washers and nuts.
Do not tighten nuts. Leave assembly loose,
so you
can make adjustments to support
assemblies later.
14
. Insert end tabs on wall rail through slot in
each support assembly (see Figure 16). Slide
each support assembly toward house. Be sure
wall rail is positioned firmly against exterior
wall. NOTE: If your house is constructed of a
material that could be damaged by the wall
mounting support, fasten a board between
wall rail and side of house.
. Tighten nuts securely. Tighten the nuts closest
to the wall last to assure that the wall rails
fit snugly against your house.
10