Filling Reservoir - Sharper Image SI-428 Owner's Manual

FILLING RESERVOIR

1. Place Handheld Fabric Steamer on a flat, level surface.
2. Make sure power cord is unplugged from electrical outlet.
CAUTION: If unit has been in use, allow Reservoir to cool (5 minutes for
minimum cooling before removing Water Reservoir Cap and adding water).
3. Remove Water Reservoir Cap by turning clockwise.
4. Carefully fill Reservoir with water from a faucet, bottle or cup. Use Reservoir
Level Window to gauge water level, stopping when it reaches the MAX mark.
WARNING: MAX mark on Reservoir Level Window represents the unit's maximum
usable water capacity (4.0 oz. / 118 ml.). Exceeding this amount will result in water
spitting from Steam Nozzle.
NOTE: In order to minimize potential mineral build-up and prolong the life of your
Handheld Fabric Steamer, distilled or de-mineralized water is recommended
when filling Reservoir.
5. Replace Water Reservoir Cap by turning counter clockwise and until the arrows
are aligned.
CAUTION: IF UNIT TIPS OVER WHILE TURNED ON AND PRODUCING STEAM, IT
WILL CONTINUE TO PRODUCE STEAM. USE CAUTION WHEN PICKING UNIT UP.
English 9