Do you have a question about the VDR CT-1000 and is the answer not in the manual?
Questions and answers
Tim barron
May 14, 2025
I purchased an aptiv pp 107201 for my 2005 peterbilt. I cannot anywhere, find a wiring diagram for the install. Yes, i have downloaded the corresponding manual but it doesnt mention what the wires are for. Please help.
1 comments:
Mr. Anderson
May 21, 2025
The wiring diagram for the Aptiv VDR CT-1000 is not specific to a 2005 Peterbilt in the provided information. However, general connection steps include:
1. Connect the VDR to the vehicle using the OBD or another harness. 2. Attach the GPS antenna on a flat surface with a clear view of the sky. 3. Connect the cell antennas: - CELL-1 antenna should be positioned vertically. - CELL-2 antenna should be positioned horizontally. 4. Optional: Connect Wi-Fi antennas to WIFI-1 and WIFI-2 if used. 5. Connect the manual trigger in a place easily reachable by the driver. 6. Wait 5 minutes after starting the vehicle and check indicator lights.
Match all accessories to the labels on the VDR ports. Port order may vary by model.
Page 2
If C is green and B is not, call your Aptiv representative. If accessories to the labels on the ports. both B and C are unlit, follow the directions for C below.
Need help?
Do you have a question about the VDR CT-1000 and is the answer not in the manual?
Questions and answers
I purchased an aptiv pp 107201 for my 2005 peterbilt. I cannot anywhere, find a wiring diagram for the install. Yes, i have downloaded the corresponding manual but it doesnt mention what the wires are for. Please help.
The wiring diagram for the Aptiv VDR CT-1000 is not specific to a 2005 Peterbilt in the provided information. However, general connection steps include:
1. Connect the VDR to the vehicle using the OBD or another harness.
2. Attach the GPS antenna on a flat surface with a clear view of the sky.
3. Connect the cell antennas:
- CELL-1 antenna should be positioned vertically.
- CELL-2 antenna should be positioned horizontally.
4. Optional: Connect Wi-Fi antennas to WIFI-1 and WIFI-2 if used.
5. Connect the manual trigger in a place easily reachable by the driver.
6. Wait 5 minutes after starting the vehicle and check indicator lights.
Match all accessories to the labels on the VDR ports. Port order may vary by model.
This answer is automatically generated