1. Remove the base plate ➀ and place it with the set-up side (feet / felt) on the table.
2. Screw the rear panel ➁ onto the base plate. The MATT painted side is the inner side.
3. Now the side parts ➂ must be screwed to the bottom wall ➀ and the rear wall ➁. The
MATT painted side is the inner side.
4. Missing light sources must be screwed into the lighting segment.
(The power supply must not yet be established)
5. The lighting segment ➃ must now be plugged onto the body. Make sure that the cover
clasps the edges of the body.
6. Now the power supply must be established with the supplied cold-device plug.
The connection is located on the rear side of the lighting segment.
© PCE Instruments
4