ABB Relion 620 Series Manual page 53

1MAC302441-MB A
RER620
Point List Manual
IEC 60870-5-101/104 protocol implementation
8.6 Basic Application Functions
Station initialization
(station-specific parameter, mark "X" if function is used)
Remote initialization
Cyclic data transmission
(station-specific parameter, mark "X" if function is only used in the standard direction,
"R" if only used in the reverse direction, and"B" if used in both directions)
X
Cyclic data transmission
Read procedure
(station-specific parameter, mark "X" if function is only used in the standard direction,
"R" if only used in the reverse direction, and "B" if used in both directions)
X
Read procedure
Spontaneous transmission
(station-specific parameter, mark "X" if function is only used in the standard direction,
"R" if only used in the reverse direction, and "B" if used in both directions)
X
Spontaneous
Double transmission of information objects with cause of transmission spontaneous
(station-specific parameter, mark each information type "X" where both a Type ID without
time and corresponding Type ID with time are issued in response to a single spontaneous
change of a monitored object)
The following type identifications may be transmitted in succession caused by a single
status change of an information object. The particular information object addresses for
which double transmission is enabled are defined in a project-specific list.
X
Double-point information M_DP_NA_1, M_DP_TA_1 and M_DP_TB_1
Step position information M_ST_NA_1, M_ST_TA_1 and M_ST_TB_1
Bitstring of 32 bit M_BO_NA_1, M_BO_TA_1 and M_BO_TB_1
X
Measured value, normalized value M_ME_NA_1, M_ME_TA_1, M_ME_ND_1 and M_ME_TD_1
X
Measured value, scaled value M_ME_NB_1, M_ME_TB_1 and M_ME_TE_1
X
Measured value, short floating point number M_ME_NC_1, M_ME_TC_1 and M_ME_TF_1
Section 3
(if defined for a specific project, see 7.2.1.1)
47