Advertisement
TRIANGLE
3.2.4 Assembly of PV modules onto aluminium
profiles:
Installation of PV modules directly onto aluminium profiles is performed
when the required disposition of PV modules is in portrait.
PV modules will be fixed at 4 attachment points, as shown in the kit
drawing.
The assembly of PV modules is performed with "L" aluminium pieces
(individual fixations), "U" aluminium pieces (double fixations), DIN 912
M8x70 A2 bolts, DIN 6798A M8 A2 washers and M8 A2 spring nuts as
shown in images above.
NEEDED TOOLS AT THIS STEP ARE:
•
Hexagonal wrench 6mm.
8
3.2.5 General considerations:
Torque settings for fasteners:
1. M8 nuts and bolts: 23 Nm.
2. M10 nuts and bolts: 43 Nm.
PV modules attachment points:
Attachment points of PV modules are approximately at ¼ of the longest
side measured from the end of the module, always prevailing
manufacturer recommendations over this issue.
Minimum distances for anchorages position:
The minimum distance to be kept from the end of the aluminium profile to
place any anchorage or fixation is 50mm.
4. DO'S AND DON'TS :
•
Installation of PROINSO PV RACK intended to be Performed by
Trained Installers.
•
Please Ensure all Safety Equipment shall be use by Installers.
•
Please Ensure Substructure , Super Structure of Roof can with stand
load of PROINSO PV RACK and Live load during Installation.
•
Do not modify any Product of Proinso PV RACK without any Prior
Approval by Engineers.
•
Please follow recommended instructions of solar module
manufacturer during handling and installation.
•
Please ensure Solar module can Install on Rail one at a time, Please
take care for slipping of module.
9
Advertisement
