Advertisement
General Safety Instructions (Cont.)
Cleaning and maintenance
• Disconnect: Unplug the appliance before cleaning or servicing (when the appliance
is operating, the condenser and compressor will be hot). Failure to disconnect
it before cleaning can result in electric shock, injury or death. Do not connect or
disconnect the plug when your hands are wet.
• Flames: Do not let open flames or ignition sources enter the appliance.
• Flammable/explosive substances: Never clean this appliance with flammable fluids.
Do not store or use volatile, flammable or explosive substances such as aerosol cans
with a flammable propellants in or close to this or any other appliance. The fumes can
create a fire hazard or explosion.
• Solvents: Do not use solvent based cleaning agents or abrasives on the interior as
these may damage or discolour the surfaces of the appliances.
WARNING!
Do not use mechanical devices or other means to accelerate the
•
defrosting process. Never use a sharp or metal instrument to remove frost or clean
the appliance. Use a plastic scraper, if necessary.
• Service: Do not attempt to repair, modify or replace any part of the appliance
unless specifically recommended in this manual. Refer all other servicing to
a qualified technician, or contact the after sales support line for advice on
examination or repair of the appliance.
Installation
(see page 10 for more comprehensive installation instructions)
• Heavy: This fridge is heavy, take care when moving it. To avoid injury, consider a two
person lift or mechanical aid when installing it. Failure to do so can result in back or
other injury.
• Freestanding design: This appliance is designed to be freestanding only and should
not be recessed or built in. Do not place anything on top, keep the top clear.
• Keep it upright: Do not tilt the fridge more than 45º from upright when moving it.
WARNING:
Never put the appliance upside down.
• Handle with care: Do not apply force to any part such as the condenser or door.
•
WARNING:
Ventilation: To ensure proper ventilation, keep any ventilation openings,
in the appliance enclosure or in the built-in structure, clear of obstructions. Ensure
adequate air circulation around the appliance to prevent overheating.
• Level: Install the appliance level in order to ensure proper operation. If necessary,
adjust the levelling legs at the bottom of the unit.
• Location: Install the appliance in an area that meets the following requirements:
- The ambient temperatures must correspond to the climate class (T) indicated on the
rating plate of the appliance: 16°C to 43°C.
- The floor must be sturdy, level and strong enough to support the unit when fully loaded.
- Avoid areas where the appliance would be exposed to direct sunlight, sources of heat
(stove, heater, radiator, etc.), extremely cold ambient temperatures or excessive moisture
and high humidity (such as outdoors or exposed to wind, rain, water spray or drips).
Installing it in the coolest area of the room will save energy use and running costs.
AFTER SALES SUPPORT
AUS
1300 886 649
MODEL: STR-H158W PRODUCT CODE: 703092 10/2020
info@tempo.org
7
Hide quick links:
Advertisement
