Advertisement
Installing the GPS Satellite Antenna System
NOTE
For requirements on the GPS installation, see GPS Satellite Antenna System Quick Installation Guide.
For requirements on the GPS antenna position, see Appendixes 2.
This document describes how to connect the ATOM GPS to the GPS.
Deploy amplifiers based on the GPS feeder length. Deploy one amplifier if the feeder length exceeds 80 m.
Standalone Deployment of a Lightning Protection Component
Install the dual-female conversion adapter on
the Protect interface of the lightning protection
component.
Lightning
protection
component
Dual-female
conversion
adapter
Deployment of a Lightning Protection Component Together with an Amplifier
Connect the RF IN interface of the amplifier to the
Protect interface of the lightning protection
component, and use a wrench to secure the joint.
Lightning
protection
component
Amplifier
At the joint between the coaxial cable and the
Protect interface of the lightning protection
component or the RF OUT interface of the
amplifier, implement 1+3+3 waterproof
protection. Use one cable tie on each end of
the tape to secure the adhesive tape.
Wrap one layer
Wrap three layers
of insulation
of waterproof
tape.
tapes.
Surge
Protect
Surge
Protect
Wrap three layers
Use one
of insulation
cable tie on
tapes.
each end.
Connect one end of the coaxial cable to the
Protect interface of the lightning protection
component, and use a wrench to secure the
joint.
Connect one end of the coaxial cable to the RF
OUT interface of the amplifier, and use the
wrench to secure the joint.
Install the ground cable of the lightning
protection component.
4
Ground bar
Advertisement
