Download Print this page

HP StorageWorks ESL E Series Replacement page 2

Ultrium fc drive
Hide thumbs Also See for StorageWorks ESL E Series:

Advertisement

5
Identify the drive to be replaced.
The LED of the drive to be replaced will be off.
CAUTION: To avoid damaging the drive,
do not remove it if the LED is still lit.
See step 2 to power off the drive.
7
Remove the FC cable from the cable clip.
Drive Replacement
9
2
1
1) Insert the new drive into the
vacant drive bay. 2) Tighten the captive
screw to secure the drive to the cluster.
6
Drive Removal
2
Disconnect the Fibre Channel (FC) cable from the
drive to be replaced by 1) pressing down on the
cable connector tab and 2) pulling the connector
away from the drive.
CAUTION: To avoid damaging FC
cables, do not sharply bend or pinch them.
8
1
Using a
slotted screwdriver,
1) loosen the captive screw at
the upper left corner of the drive module.
2) Move the FC cable to the side and out of the
way. Grasp the drive handle and pull the drive
from its bay.
10
Connect the FC cable to the new drive. The FC
cable connector clicks into place. Insert the cable
into the cable clip on the drive.
CAUTION: To avoid damaging FC cables,
do not sharply bend or pinch them. Allow a
radial bend when reattaching the FC cables.
1
2

Advertisement

loading