Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Dolby Laboratories DSS200
Summary of Contents for Dolby Laboratories DSS200
- Page 1 Dolby DSS200 ® System Fans Replacement Guide Issue 1 Part Number 9110720...
- Page 2 European Headquarters Dolby Laboratories, Inc. Wootton Bassett Wiltshire SN4 8QJ England Telephone 44‐1793‐842100 Fax 44‐1793‐842101 DISCLAIMER OF WARRANTIES: EQUIPMENT MANUFACTURED BY DOLBY LABORATORIES IS WARRANTED AGAINST DEFECTS IN MATERIALS AND WORKMANSHIP FOR A PERIOD OF ONE YEAR FROM THE DATE OF PURCHASE. THERE ARE NO OTHER EXPRESS OR IMPLIED WARRANTIES AND NO WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, OR OF NONINFRINGEMENT OF THIRD‐PARTY RIGHTS (INCLUDING, BUT NOT LIMITED TO, COPYRIGHT AND PATENT RIGHTS). LIMITATION OF LIABILITY: IT IS UNDERSTOOD AND AGREED THAT DOLBY LABORATORIES’ LIABILITY, WHETHER IN CONTRACT, IN TORT, UNDER ANY WARRANTY, IN NEGLIGENCE, OR OTHERWISE, SHALL NOT EXCEED THE COST OF REPAIR OR REPLACEMENT OF THE DEFECTIVE COMPONENTS OR ACCUSED INFRINGING DEVICES, AND UNDER NO CIRCUMSTANCES SHALL DOLBY LABORATORIES BE LIABLE FOR INCIDENTAL, SPECIAL, DIRECT, INDIRECT, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, DAMAGE TO SOFTWARE OR RECORDED AUDIO OR VISUAL MATERIAL), COST OF DEFENSE, OR LOSS OF USE, REVENUE, OR PROFIT, EVEN IF DOLBY LABORATORIES OR ITS AGENTS HAVE BEEN ADVISED, ORALLY OR IN WRITING, OF THE POSSIBILITY OF SUCH DAMAGES. . Part Number 9110720 Dolby and the double‐D symbol are registered trademarks of Dolby Laboratories. Issue 1 © 2010 Dolby Laboratories. All rights reserved. S10/22337 ® Dolby DSS200 System Fans Replacement Guide...
- Page 3 DSS200 System Fans Replacement Instructions Replacing a System Fan ® The Dolby DSS200 contains five heavy‐duty system fans. Three of these fans are located in the front of the chassis, and two are located in the rear. The fans circulate air to lower the DSS200 chassis’ internal temperature. They are fully hot swappable and you can remove and replace them without having to power down the unit. Before replacing a front or rear fan, open the chassis cover as follows (see Figure Press the release tabs to remove the cover from the locked position. Press both tabs at the same time. If necessary, you may need to remove the chassis cover screw. Once the top cover is released from the locked position, slide the cover toward the rear of the chassis and lift the cover off the unit. Figure 1 Figure 1 Removing the DSS200 Chassis Cover Warning: Except for short periods of time, do not operate the DSS200 with the cover removed. The chassis cover must be in place to allow proper airflow and prevent overheating. ® Dolby DSS200 System Fans Replacement Guide...
- Page 4 Locate the faulty fan. Press the release tab on the fan and pull the faulty fan upward. Slide the new fan into the fan housing, as shown in Figure 2. Be sure the power connectors are correctly aligned. The new fan will be immediately active. Figure 2 Re Fan release tab Faulty fan out Replacement fan in Figure 2 Replacing a DSS200 Front System Fan To replace a rear fan (Dolby Part Number 5700930): Locate the faulty fan. Press the release tab on the fan and pull the faulty fan upward. Slide the rear fan into the slot, as shown in Figure 3. The fan release tab is on the side closest to the power supply. Be sure that the fan is secure in the fan housing and the housing is correctly connected to the power supply. Figure 3 Fan release tab Faulty fan out...
Need help?
Do you have a question about the DSS200 and is the answer not in the manual?
Questions and answers