Notify shipper immediately. • Remove components from the shipping carton. Check that all installation parts and hardware are present. • Make complete inspection of the SIP NEO system to ensure that:...
Failure to follow them could cause serious injuries and possible property damage. DANGER – To avoid possible electrical shock, unplug dispenser prior to installation of SIP NEO All Power cords must be three-pin plugs to be grounded. Do not use two-pin plugs.
GUIDE TO INSTALLING ON BOTTLED WATER COOLER × × × × STEPS TO INSTALLING ON BOTTLED WATER COOLER Make sure unit power is unplugged from wall Drill or cut a 9/32” hole into the side of the socket. Insulation Jacket, then place it back on the Remove the units bottled water container.
INDICATOR LIGHTS ON CONTROL SYSTEM DEVICE • The indicator lights are to display the status of the system when the SIP NEO is in function. • Red light is ozone indicator and is on when O is in operation. When red light is on, sanitization is in progress. Do not dispense or drink water when the red light is on.
Page 7
Generator Programming Instructions , AP, CO and how to set date, day, and local time During normal operation, the date and time are displayed. 06 /23/ 17 F R 11:30 To enter the Device Programming mode press the UP and DOWN keys together for about 3 seconds. The following screen is displayed.
EXCLUSIONS AND LIMITATIONS - THIS LIMITED WARRANTY APPLIES ONLY TO PRODUCTS MANUFACTURED BY OR FOR SIP THAT CAN BE IDENTIFIED BY THE "SIP" TRADEMARK, TRADE NAME, OR LOGO AFFIXED TO IT. THIS LIMITED WARRANTY DOES NOT APPLY TO ANY NON- SIP PRODUCT.
Need help?
Do you have a question about the Neo3 and is the answer not in the manual?
Questions and answers