Tigertronics SignaLink SL-1+ Installation & Operation Manual page 15

·
The sound card s volume levels are now properly set.
·
If the SignaLink is attached your radio s Mic jack, then
all further adjustment of the Receive Audio level should
be done with the radio s Volume control. If you are not
able to get an adequate amount of Receive Audio with
these settings, then you can set the sound card Mic
volume control higher, or adjust the SignaLink s
internal RX Level control for more output (see the
TX Level and RX Level Controls section of this
manual).
·
If the SignaLink is attached your radio s Data or
Accessory Port, then all further adjustment of the
Receive Audio level should be done with the sound
card s Mic volume control, or the SignaLink s internal
RX Level control (see the TX Level and RX Level
Controls section of this manual).
·
Click the X in the upper right hand corner of the
Volume Control window to close it and save your
settings.
NOTE: If you are unable to get an adequate Receive Audio
level, then please see the Troubleshooting section of this
manual for possible causes.
SignaLinkä and AutoPTTä are trademarks of Tigertronics
Copyright © 2001-2015 Tigertronics - All Rights Reserved
(
3/03/06 Rev-C)
15