Contents; Installation - AquaScape Waterfall Spillway 22 Instructions & Maintenance

Contents

No. B Description
1. Waterfall Spillway
2. 2" MPT x Slip
3. Multi-Hose Adapter 2"MPT x 1.5", 2" Barbed

Installation

A
STEP 1
BUILD WATERFALL AND STREAM
REV DESCRIPTION
• Build waterfall and stream, providing enough liner at the
top of the waterfall to wrap over the top of the Waterfall
Spillway.
1
HOLE PROTOTYPE LOCATION RELEASE
STEP 2
PLACE WATERFALL SPILLWAY
• Set the Waterfall Spillway into the desired location
(Ex. 1). Ensure the top of the spillway is facing upward
(Ex. 2).
Ex. 1
• Adjust the height of the Waterfall Spillway to match the
starting point of the waterfall. A bed of gravel can be
placed on top of the liner, beneath the Waterfall Spillway,
to raise the height of the spillway to the desired level
(Ex. 3).
• Level the spillway from side-to-side and tilted forward a
1/4" bubble on a 2 foot level (Ex. 4).
Ex. 3
☎
aquascapeinc.com | CAN (866) 766-3426 |
2
1
NAME DATE UNLESS OTHERWISE SPECIFIED:
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN DIMENSIONS ARE IN INCHES
THIS DRAWING IS THE SOLE
TOLERANCES:
PROPERTY OF AQUASCAPE INC.
FRACTIONAL 1/16
ANY REPRODUCTION IN PART OR
ANGULAR: MACH 5 BEND 5
AS A WHOLE WITHOUT THE WRITTEN
TWO PLACE DECIMAL
PERMISSION OF AQUASCAPE INC IS
THREE PLACE DECIMAL
PROHIBITED.
EAK 8/13/19
2
Top
Flat Bottom
Ex. 2
Ex. 4
☎
US (866) 877-6637
NOTE: TITLE BLOCK TOLERANCE
NOT APPLICABLE
SURFACE AREA: 592 SQUARE INCHES
STEP 3
CONNECT TO LINER
TITLE:
CREATED BY CREATED DATE
EAK 8/13/19
• Fold the liner over the top of the Waterfall Spillway. It
CHECKED BY CHECKED DATE
DWG. NO.
is recommended to provide some slack in the liner in
.010
case the position of the Waterfall Spillway needs minor
.005
SCALE: 1:5
INTERPRET GEOMETRIC TOLERANCING PER: ANSI
adjustment during installation (Ex. 5).
• Using a screw driver or awl, puncture a small hole in the
liner through the center of the Waterfall Spillway fitting
(Ex. 6). This will be your reference point for the location of
the liner connection.
Ex. 5
• Unfold the liner back off the Waterfall Spillway and remove
the retaining nut from the Waterfall Spillway fitting. Center
the retaining nut over the puncture hole in the liner. Use a
pen marker, awl, or screwdriver to trace a line around the
inside of the nut (Ex. 7).
• Remove the retaining nut and trim a hole in the liner
approximately 1/8" inside of the score mark (Ex. 8).
Ex. 7
1
B
ai15789439865_77024_LINEDRW_Spillway Fitting 2 in.pdf 1 1/13/2020 1:33:06 PM
2
C
M
Y
CM
MY
CY
CMY
K
A
SMALL SPILLWAY QUOTE
77023-XX-XX-XX-2
SIZE A SHEET 3 OF 3
1
3
Ex. 6
Ex. 8
3