Advertisement
3. How to set up a Bluetooth connection with
Android devices
S S tep 1 Configure output interface of the scanner to
be H H ID by scanning the sequence of barcodes as
the below figure shows.
e shows.
ENTER
*/$%ENTR*
HID
*5OZ3*
END
*ZEND*
Step 2 Switch your scanner to Bluetooth Mode.
ENTER
*/$%ENTR*
*ZTOB*
Step 3 Pair your scanner with Android devices.
ENTER
*/$%ENTR*
*ZPAR*
Step 4 Turn on Bluetooth setting in your Android
device. From the list of available Bluetooth devices,
appropriately select the device which your intend to
pair Android phone with.
Step 5 According to the pop-up message which
contains PinCode info, please properly scan the
sequence of decimal barcodes from
Decimal/Hexadecimal Table in Section 2. Then, scan
SET label in the same table to initiate the pin code
verification.
Step 6 After Bluetooth connection is successfully
established, launch a text editing application to
receive barcode data.
4. How to set up a Bluetooth connection with
termial programs via SPP Master interface
Step 1 After the Bluetooth dongle is secured into Host
PC, please go to C C ontrol Panel>B B luetooth Settings.
Step 2 In B B luetooth Settings, click on C C OM Ports tab
and then hit A A dd button to add an incoming port.
To BT Mode
Step 3 In A A dd COM Port dialogue box, select I I ncoming
option and then hit O O K button to initiate the process.
Step 4 Back to B B luetooth Setting, if the incoming port
BT Pairing
is successfully generated, the list box in C C OM ports
tab will show associated information regarding the
incoming port.
2
Step 5 Launch the terminal simulation application
to configure COM Port with the incoming port you
generate in step 4 and ensure the application is
connected using specified COM port.
Step 6 Configure output interface of the scanner to
be S S PP Master by scanning the sequence of
barcodes as the below figure shows.
ENTER
*/$%ENTR*
SPP Master
*5OZ2*
Step 7 Follow the below steps to configure pin code
information.
ENTER
*/$%ENTR*
BtPinCode
*95C+*
Scan the sequence of
barcodes
SET
*%OK*
corresponding to the
desired pin code from
decimal/hexadecimal
END
*ZEND*
table in Section 2.
END
*ZEND*
Advertisement
