2D
wireless
Barcode
Reader
Quick Start
JBS-8H03-A
2D Bluetooth Barcode Scanner
1. Product Overview
Press Scan Button to read barcodes.
1
Press S S mall Trigger to perform supplementary
2
fucntions.
Good Read Indicator inidicates whether the barcode is
3
decoded. Green LED shows a successful decodeing
attempt.
Mode Indicator indicates the current operation mode
4
status. Blue LED stands for Bluetooth mode, green LED for
Cable mode, and orange LED for Memory mode
Power Indicator indicates the battery charge status.
5
Strape Hole
6
Secure the interface cable into U U SB Port to charge the
7
battery compartment
2. How to set up a Bluetooth connection with
iOS devices
S S tep 1 Configure output interface of the scanner to be
iOS by scanning the sequence of barcodes as the
below figure shows.
ows.
ENTER
*/$%ENTR*
iOS
*5OZ4*
END
*ZEND*
1
Step 2 Switch your scanner to Bluetooth Mode.
ENTER
*ZTOB*
*/$%ENTR*
Step 3 Pair your scanner with iOS devices.
ENTER
*/$%ENTR*
*ZPAR*
Step 4 Turn on Bluetooth setting in your iOS
Product. From the list of available Bluetooth
devices, appropriately select the device which your
intend to pair iOS product with.
Step 5 According to the pop-up message which
contains PinCode info, please properly scan the
sequence of decimal barcodes from
Decimal/Hexadecimal Table in Section 2. Then,
scan S S ET label in the same table to initiate the pin
code verification.
Step 6 After Bluetooth connection is successfully
established, press Home button and launch N N otes
application to receive barcode data.
To BT Mode
BT Pairing